What To Do About Low Pressure in Your Water Flosser

How to clean your Water Flosser Jet Tips:

1. Remove the Water Flosser tip from the unit using the eject button.
2. Soak the tip in a container of hydrogen peroxide or white vinegar for 5-7 minutes.
3. Rinse the tip under warm water.

Note: For maximum effectiveness, replace Water Flosser tips every 3-6 months as the tips can become clogged and/or affected by mineral deposits.

How to clean your Water Flosser:

Clean your Water Flosser every 1 to 3 months to ensure optimal performance.

For Countertop models:

Remove the Water Flosser tip from the unit using the eject button.

1. Mix 2-4 tablespoons (1-2 ounces) of white vinegar with 16 ounces of warm water.
2. Fill the reservoir with the solution, and then run 1/2 of it through the Water Flosser.
3. With the unit off, place the Water Flosser handle in the sink and allow the solution to gradually drain out of the handle.
4. Run any remaining solution through the unit and then rinse with a full reservoir of warm water.

For Cordless models:

1. Add 1 tablespoon of white vinegar to a full reservoir of warm water.
2. Point the handle and tip into the sink.
3. Turn unit ON and run until reservoir is empty.
4. Rinse by repeating with a full reservoir of clean warm water.

To replace the batteries Cordless Freedom WF-03 Water Flosser:

1. Replace batteries when there is a noticeable change in performance.
2. The type and quality of AA battery used impacts performance of the product.
3. Use 3 AA Batteries (Alkaline Or NiMH Only)
4. Replace all batteries at the same time with new batteries of the same type and brand.

To charge the Cordless Advanced Water Flosser WP-560/562/563:

1. Charge the unit prior to first use by plugging the power cord into the wall and place the magnetic charger on the front of the unit for approximately 4 hours.
2. The charge indicator on the handle flashes when charging and stays on continuously when the unit is fully charged. A full charge lasts for approximately 1 week of typical use.
3. When there is approximately 30% charge left, the charge indicator light blinks 8 times quickly after use to indicate that you should recharge the unit. A complete recharge takes 3-4 hours.

To charge the Cordless Plus Water Flosser WP-450:

1. Ensure the power switch is in the OFF position when charging.
2. If you use your Water Flosser once a day or less, charge it overnight, once a week. If you use it twice a day or more, charge the unit more frequently.
3. Do not run the battery down completely. This may shorten the battery lifespan and requires charging the unit for 24 hours to obtain a full charge.
4. If the Water Flosser is to be stored for an extended period of time (six months or more), be sure to fully charge it prior to storage. The unit contains a Nickel Metal Hydride battery.